92
Description
G-30-1607-en
OPMI® VARIO on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 30. 01. 2009
Powering on the TFT monitor
To facilitate the operation of the TFT monitor, it is automatically activated
when the suspension system is switched on.
During the power-on process, the TFT monitor executes a power-on se-
quence in which the signals on the connectors (DVI, VGA, S-Video, Com-
posite and Component) are checked. After detection of the signal avail-
able, the correct screen resolution and frame rate are set automatically.
Aligining the video monitor
The best visualization is obtained when you are looking straight at the
screen of the TFT monitor.
•
Swivel the monitor's carrier arm (1) and suspension arm (2) into the
horizontal position required.
Caution:
Take care not to damage the video cable!
Do not swivel the suspension arm beyond ±120°.
•
Tilt the suspension arm (2) upward or downward until the required
height has been reached.
•
Hold the upper corners of the TFT monitor and adjust it to the required
angle via ball joint (3).
Warning!
Risk of injury due to lowering of the TFT monitor!
•
Ageing processes may lead to the loss of gas in the gas pressure
spring of the monitor's suspension arm, causing the TFT monitor to
move downward of its own accord.
Compensate for the loss of gas by readjusting the gas pressure spring
as described on page 218.
If the TFT monitor continues to move downward, the gas pressure spring
is defective.
•
Notify our service representative.
