214
Maintenance / Further information
G-30-1607-en
OPMI® VARIO on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 30. 01. 2009
Changing the xenon lamp module
Warning!
The lamp module must only be changed by appropriately trained per-
sonnel. Improper handling of the xenon lamp may lead to damage or in-
jury.
Warning!
Lamp rupture (audible as a loud bang) may lead to jamming of the lamp
module and/or failure of the electronics modules.
•
Before opening the lamp housing, make sure that the system is moved
to a position where neither the patient nor the user is put at risk by fall-
ing items.
•
Do not continue using the system if the lamp module is jammed or the
illumination is no longer operational due to defective electronics mod-
ules. Inform our service department.
Change the lamp module as follows:
•
First switch off the suspension system at the power switch.
•
Only change the lamp module after it has cooled down completely! In
the event of a malfunction, there is a risk of explosion due to the high
pressure inside the hot lamp. The hot surface of the xenon lamp may
also cause burns.
•
Only change the module after switching off the system. The igniter
produces high voltage when the system is on.
•
Press button (1). The lamp module is slightly ejected.
•
Pull out the lamp module as far as it will go.
•
Slide the original transport case (2) over the module, making sure that
bolt (3) engages in bore (4). This unlocks the stop.
•
Remove the old module and install the new lamp module by proceed-
ing in the reverse order.
•
Check the function of the xenon lamp and backup xenon lamp.
