172
Operation
G-30-1607-en
OPMI® VARIO on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 30. 01. 2009
Basic mode
The basic mode is always displayed in the normal operating status and
after power-on of the system.
In the basic mode, the following settings are displayed, depending on the
installed surgical microscope:
Setting the user ID (USER)
The lower display field in the basic mode generally shows the current
USER, i.e. the user ID selected when the system was last switched off is
displayed. When the user is changed, all settings for the newly selected
user will be loaded, except the lamp brightness which is always set to the
minimum value.
User data records can be stored for a maximum of 9 different users.
Use buttons "
∇
" and "
Δ
" assigned to the lower display field to select a user
ID between 1 and 9.
Saving parameter settings
As soon as you have entered a parameter setting, it is saved under the
current user ID.
Note:
If possible, each user should be assigned his own user ID under which he
can enter and save his specific parameter settings. This permits each
user to call up his specific set of parameters via his user ID and to work
with these settings.
Note:
Make sure not to change the settings of another user. It is advisable to
work only under your own user ID, as all settings are always saved under
the currently selected USER.
In the upper display field the current lamp brightness
In the middle display
field
for OPMI
®
Vario on the suspension system:
either the working distance or the
total magnification
In the lower display field the user ID
MODE
STORE MANUAL
USER
1
250 mm
1
5.0
Basic mode
