218
Maintenance / Further information
G-30-1607-en
OPMI® VARIO on S8, S81 & S88 Suspension Systems
Issue 5.0
Printed on 30. 01. 2009
Adjusting the monitor arm
If the TFT monitor does not remain in place in the required position, you
can increase the resistance of the following components:
Resistance on the carrier arm (left/right)
•
Slightly tighten screw (1) of the carrier arm by turning it clockwise us-
ing an M5 hex key.
Resistance on the suspension arm (left/right)
•
Remove plastic cover (2) on the suspension arm joint.
•
Loosen screw (4) on the carrier arm by turning it counterclockwise us-
ing an M2.5 hex key.
•
Tighten adjustment screw (3) of the suspension arm by turning it
clockwise until the required friction has been obtained.
•
Firmly retighten screw (4) on the carrier arm by turning it clockwise us-
ing an M2.5 hex key.
•
Reattach plastic cover (2).
Resistance on the gas pressure spring (upward/downward)
•
For correct adjustment of the gas pressure spring, align the carrier and
suspension arms in a horizontal position.
•
Tighten setting screw of the gas pressure spring (5) by turning it
coun-
terclockwise
with an M5 hex key until the suspension arm with the
TFT monitor no longer moves downward by itself.
Note:
If the suspension arm with the TFT monitor continues to move down-
ward, the gas pressure spring is defective. Notify our service repre-
sentative.
Resistance on the ball joint
•
Tighten all of the four securing screws (6) of the ball joint by turning
them clockwise until the TFT monitor remains in the required position.
Note:
After adjustment, please check whether the TFT monitor remains in
the required position.
