![background image](http://html2.mh-extra.com/html/zeiss/evo/evo_instruction-manual_3401314009.webp)
ZEISS
2 Safety | 2.1 Intended Use
2 Safety
This chapter contains general requirements for safe working practices. Any person using the Mi-
croscope System or commissioned with installation or maintenance must read and observe these
general safety instructions. Knowledge of basic safety instructions and requirements is a precondi-
tion for safe and fault-free operation. Operational safety of the supplied Microscope System is
only ensured if it is operated according to its intended use.
If any work is associated with residual risks, this is mentioned in the relevant parts of this docu-
ment in a specific note. When components must be handled with special caution, they are
marked with a warning label. These warnings must always be observed.
2.1 Intended Use
The microscope has been designed to generate an image or to analyze appropriate specimens,
which is achieved by scanning a focused electron beam across the specimen (SEM Imaging).
This application allows for the imaging and analysis of surface structures and near-surface struc-
tures of appropriate specimens. For this purpose, the specimen is placed in the evacuated speci-
men chamber.
Info
Not for therapeutic, treatment, or medical diagnostic evidence.
Info
Not all products are available in every country. Contact your local ZEISS representative for
more information.
PC
The Zeiss SEM PC is supplied “as is” and is untested with any third-part software. It is not recom-
mended to install any third-part software on the Zeiss SEM PC as this might cause instabilities
and/or break Carl Zeiss software installations.
SmartSEM
Software
The SmartSEM software is intended for the operation of scanning electron microscopes (SEMs).
The SmartSEM software has to be run exclusively on a personal computer delivered by ZEISS. Any
other application is not allowed.
Regarding the operation of the microscope, the following regulations must be met:
§
Only operate the microscope according to the operating conditions after correct installation
by a ZEISS service representative.
§
The microscope is only to be used by operators who have been trained by a ZEISS service rep-
resentative. Basic operator training and safety instructions will be provided within the scope
of the initial start-up by ZEISS. Make sure that everyone who operates the microscope only
performs the tasks for which he/she is trained.
§
Operators of the microscope must not deviate from the instructions provided in this manual.
§
Only perform preventive maintenance tasks described in this manual. All tasks of mainte-
nance, service, and repair not described in this manual have to be performed by an authorized
ZEISS service representative.
§
The microscope is to be used in a laboratory environment for commercial and scientific pur-
poses only.
Using the microscope for any other purpose is not allowed and can be hazardous.
Improper use of the Microscope System can easily lead to impairment of its function or even dam-
age to the Microscope System. Damage caused by incorrect operation, negligence or unautho-
rized intervention, in particular by removing, modifying or replacing parts of the Microscope Sys-
tem, cannot be held liable by the device manufacturer. Third-party devices or components that
are not expressly approved by ZEISS may not be used.
Instruction Manual ZEISS EVO | en-US | Rev. 10 | 354706-0780-006
9
Summary of Contents for EVO
Page 1: ...Instruction Manual ZEISS EVO Scanning Electron Microscope...
Page 179: ......