![background image](http://html2.mh-extra.com/html/zeiss/evo/evo_instruction-manual_3401314010.webp)
2 Safety | 2.2 General Safety Information
ZEISS
2.2 General Safety Information
This document must be read before commissioning in order to ensure safe and uninterrupted op-
eration. Pay particular attention to all listed safety notes. Make sure, that
§
the operating personnel has read and understood this manual, associated documents and
particularly all safety regulations and instructions, and applies them.
§
the local and national safety and accident prevention regulations must be observed, as well as
the applicable laws and regulations in your country.
§
this document is always available with/together with the Microscope System.
§
the Microscope System is always in perfect condition.
§
the Microscope System is secured against access by unauthorized persons.
§
maintenance and repair work, retrofitting, removal or replacement of components, as well as
any other intervention in the Microscope System not described in this document, may only be
carried out by the manufacturer ZEISS or persons expressly authorized by ZEISS to do so.
2.2.1 Requirements for Operators
The Microscope System, components and accessories may only be operated and maintained by
authorized and trained personnel. The Microscope System may only be used in accordance this
document. If the Microscope System is not used as described, the safety of the user may be im-
paired and/or the Microscope System may be damaged.
Any unauthorized intervention or use other than within the scope of the intended use shall void
all rights to warranty claims. The regional regulations on health protection and accident preven-
tion must be observed at all times and during all work on and with the Microscope System.
Training
Authorized ZEISS personnel will provide basic training in operating the Microscope System. As
well as information on equipment safety and maintenance work that can be conducted by the op-
erator. The training will be documented by ZEISS and its completion is to be confirmed by the op-
erator.
Special application training is offered for a fee. Current training dates, additional information and
the registration form can be found at
https://www.zeiss.com/microscopy/int/service-support/train-
2.2.2 Safe Operating Condition
If circumstances occur which impair safety and cause changes in operating behavior, the Micro-
scope System must be shut down immediately and a ZEISS service representative should be in-
formed. The Microscope System can only be operated after proper installation by a ZEISS service
representative and in compliance with the operating conditions. The Microscope System may only
be operated after correct installation by a ZEISS service representative and if the operating condi-
tions are adhered to.
§
Do not operate the Microscope System until you have completely read and understood the
entire documentation delivered with the Microscope System.
§
Make sure that all protective cover panels are installed and all warning labels are available and
legible.
§
Ensure conditions and take measures to prevent the build up of electrostatic charge on the
workplace.
10
Instruction Manual ZEISS EVO | en-US | Rev. 10 | 354706-0780-006
Summary of Contents for EVO
Page 1: ...Instruction Manual ZEISS EVO Scanning Electron Microscope...
Page 179: ......