YOKOGAWA ZR202S, User Manual, Page: 69 / 163

<7. Startup>
7-6
IM 11M13A01-04E
CAUTION
• If no key is touched for at least 20 seconds during password entry, the current display will
automatically switch to the basic panel display.
• If no key is touched for at least 10 minutes during parameter code selection, the current display
will automatically switch to the basic panel display.
7.4.4 Selecting Parameter Codes
Table7.4 Parameter Code
Switch operation Display Description
> ∧
ENT
A01
Password has been entered and the parameter code selection display has
appeared. Character A is flashing, indicating that character A can be changed.
> ∧
ENT
A 0 1
If you touch the [ > ] key once, the position of the digit that is flashing will move to
the right. This allows you to change 0.
> ∧
ENT
A0 1
Touch the [ > ] key again to move the position of the digit that is flashing to the right
one more digit. This enables you to change numeric value to 1.
> ∧
ENT
A 01
Touch the [ > ] key again to return the position of the digit that is flashing to A.
Continuously touch the [ > ] key, and the position of the digit that is flashing will
move continuously to the right.
> ∧
ENT
b 01
If you touch the [ ∧ ] key once, character A will change to b.
> ∧
ENT
C 01
Touch the [ ∧ ] key once to change to C.
> ∧
ENT
d 01
Continuously touch the [ ∧ ] key, and the value of the digit that is flashing will
increase continuously, from d to E to F to G to A. Numeric values will change from
0 to 1 to 2 to 3 … to 8 to 9 and back to 0. However, numbers that are not present
in the parameter codes will be skipped. Each digit is changed independently. Even
though a low-order digit changes from 9 to 0, a high-order digit will not be carried.
> ∧
ENT Set
Value
After you select the desired character, touch the [ENT] key. The set data will be
displayed.
The symbol [ ] indicates that the key is being touched. Light characters indicates that the digits are flashing.