4-6
IM DL350-03EN
4.4 GO/NO-GO Determination I/O (GO/NOGO)
CAUTION
• Do not apply external voltage to the NOGO and GO output pins. Doing so may damage the
instrument.
• When connecting the GO/NO-GO determination signal output to another device, do not
connect the wrong signal pin. Doing so may damage this instrument or the connected
device.
French
ATTENTION
• Ne pas appliquer de tension externe aux broches de sortie NOGO et GO. Cela pourrait
endommager l’instrument.
• Lors de la connexion de la sortie de signal de détermination GO/NO-GO à un autre
appareil, veiller à ne pas connecter la mauvaise broche de signal. Cela pourrait
endommager cet instrument ou l’appareil connecté.
GO/NO-GO Determination I/O Terminal (GO/NOGO)
NOGO: NO-GO output, active low (NO-GO)
GO: GO output, active low (GO)
STRT: Low to execute determination (when GO/NO-GO
external start (Remote) is set to ON)
You can apply an external signal to the instrument’s GO/NO-GO I/O terminal and perform GO/ NO-GO
determination, and you can output the results of GO/NO-GO determination from the GO/NOGO I/O
terminal.
Item
Specifications
I/O level
0 to 5 V
Threshold level
TTL
Input Signal (STRT)
STRT (Negative logic)
Use this signal to perform GO/NO-GO determination by synchronizing to an external input signal. The
signal is only valid when on the GO/NO-GO menu, external start (Remote) is set to ON. If external
start is set to OFF, GO/NO-GO determination is performed regardless of the external signal input (the
GO/ NOGO determination result is output).