3-17
E
INSP
ADJ
POWER TRIM AND TILT SYSTEM
Checking steps
(1) Tilt the outboard all the way up and
lock it with the tilt stop levers
1
.
WARNING
After tilting up the outboard, be sure to
support it with the tilt stop levers.
Otherwise, the outboard could suddenly
lower if the power trim and tilt unit should
lose fluid pressure.
(2) Remove the reservoir cap
2
and check
the fluid level.
NOTE:
The fluid level should be directly below the
check hole as shown.
(3) Add power trim and tilt fluid if needed,
and then install the reservoir cap.
T
R
.
.
Reservoir cap
8 Nm (0.8 m • kgf, 5.8 ft • lb)
3310
3320
ADJUSTING THE TRIM SENSOR CAM
3
1. Measure:
• Trim sensor setting resistance
Out of specification
→
Adjust.
Measuring steps
(1) Fully tilt the outboard down.
(2) Measure the trim sensor resistance.
Trim sensor setting resistance
Pink (P) – Black (B)
10
±
1
Ω
at 20 ˚C (68 ˚F)
3323
