ADPRO FastTx by Xtralis
Installation and User Manual
Doc 11949_06
51
4 Programming ADPRO FastTx
4.1
Programming Checklist
The following checklist provides an overview of the main tasks required to program an ADPRO
FastTx and the sequence in which they should be performed:
•
Set the unique Site ID and Password for the ADPRO FastTx and ensure that matching ones
are entered in ADPRO VideoCentral (refer to “
Site Details
” on page 55).
•
Set the time zone on the ADPRO FastTx to the time zone of the site location (refer to “
Date/
Time Settings
” on page 56).
•
Set the communication properties for the ADPRO FastTx to dial out (refer to
“
Communications
” on page 58).
•
Ensure the Call List numbers / addresses are those required to contact the CMS (refer to
“
Call List
” on page 67).
•
Ensure all connected cameras are programmed (refer to “
Cameras
” on page 71 and
“Camera Behaviour” on page 93).
4.2
Setting the Operational Parameters
The ADPRO FastTx is factory configured with 'typical' operating values, but to use the ADPRO
FastTx in an operational environment, its configuration must be modified to use the site names,
phone numbers or network addresses that match the real network.
Once the ADPRO FastTx settings have been configured, the ADPRO VideoCentral settings must
be updated to match.
4.2.1 Setting the Telephone Connection
The basic information needed to use a telephone (dial-up) connection is entered via the
Database
/
Administration
/
Configure Sites
menu. Select the
Edit
option, then highlight
PSTN
or
ISDN
in the Communications section:
•
Site ID
: 9 characters (max)
•
Password
: 8 characters (max)
•
Hunt Group
: Select from the list (
Note
: Different modem types must be installed via the
Windows Control Panel)
•
Phone Number
: Enter the phone number of the modem connected to the ADPRO FastTx.
4.2.2 Setting the Network Connection
The ADPRO Video Central software will require some basic information in order to connect to
any ADPRO FastTx site via a network connection. The minimum information that must be
configured in each ADPRO FastTx is shown below.
To enter the information, go to
Database
/
Administration
/
Configure Sites
, select the
Edit
option, then highlight
Network
in the Communications section.
•
Site ID
: 9 characters (max)
•
Password
: 8 characters (max)
•
IP Address
: The TCP/IP network address assigned to each ADPRO FastTx (this address is
normally assigned by the network manager)
