42
EtherTalk (AppleTalk) Configuration
The EtherTalk Protocol enables workstation to Device communications over the EtherTalk (AppleTalk)
network.
To access EtherTalk Settings at the Device
1.
Press the
Log In / Out button
on the Control Panel.
2.
Press the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3.
Press
Enter
on the touch screen.
4.
Press the
Machine Status button
on the Control Panel.
5.
Press the
Tools tab
.
6.
Press
Connectivity & Network Setup
.
7.
Press
Port Settings
.
8.
Press the
EtherTalk
selection line on the Port Settings menu.
9.
Press the
Change Settings
button in the lower right corner of the Port Settings menu screen.
10. When the EtherTalk selection menu displays, note that you have only one selection available on a
single, numbered horizontal line, with the current status of this setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the horizontal
line selection, to access available settings press the Change Settings button in the lower right corner of
the touch screen.
Summary of Contents for WorkCentre 7335
Page 1: ...System Administrator s Guide 701P47693 WorkCentre 7328 7335 7345...
Page 12: ...x...
Page 300: ...701P47693...
