8
Parallel Port Configuration
To view or change the settings of the Device's parallel port, perform the following steps:
Note: You must have purchased the Parallel (1284) Printing kit and installed the supplied hardware
before you can configure this port.
To access Parallel Port Settings at the Device
1.
Press the
Log In / Out button
on the Control Panel.
2.
Press the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3.
Press
Enter
on the touch screen.
4.
Press the
Machine Status button
on the Control Panel.
5.
Press the
Tools tab
.
6.
Press
Connectivity & Network Setup
.
7.
Press
Port Settings
.
8.
Press the line labeled
Parallel
on the Port Settings menu.
9.
Press the
Change Settings button
in the lower right corner of the Port Settings menu screen.
10. When the Parallel Port selections menu displays, note that you have a choice of setting selections by
numbered horizontal lines, with the current status of each setting shown. The up and down arrow keys
provide access to additional selections and return you to the current selections display. The Close
button in the upper right corner of the screen returns you to the Port Settings menu. After pressing a
horizontal line selection, to access available settings press the Change Settings button in the lower
right corner of the touch screen.
Summary of Contents for WorkCentre 7335
Page 1: ...System Administrator s Guide 701P47693 WorkCentre 7328 7335 7345...
Page 12: ...x...
Page 300: ...701P47693...
