35
Microsoft (NetBIOS over IP) Networks
Before You Start
1.
Print a
Configuration Report
as stated in the
Network Connectivity
section of this guide.
2.
Referring to the report,
verify that SMB is enabled
. To enable SMB at the Device, if required, follow
the procedure below.
3.
Referring to the Configuration Report,
verify that DNS
is
enabled
. The use of Naming Servers is
REQUIRED to resolve NetBIOS device names to IP addresses for packet routing over the TCP/IP
network.
4.
To enable the Device to communicate with the Naming Servers, refer to the instructions supplied in the
topic "TCP/IP Dynamic Addressing", located in the
NOS Selection
section of this guide.
5.
When using WINS or DNS, be sure to refer to your Server Operating System documentation for the
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
Enabling the SMB Setting at the Device, if required
1.
Press the
Log In / Out button
on the Control Panel.
2.
Press the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3.
Press
Enter
on the touch screen.
4.
Press the
Machine Status button
on the Control Panel.
5.
Press the
Tools tab
.
6.
Press
Connectivity & Network Setup
.
Summary of Contents for WorkCentre 7335
Page 1: ...System Administrator s Guide 701P47693 WorkCentre 7328 7335 7345...
Page 12: ...x...
Page 300: ...701P47693...
