Xerox Versant 80 Press, User Manual

Page: 229 / 382

7. With the retard assembly out, access and remove the feed roll. To remove, squeeze
both ends of the metal shaft and lift out. To replace, squeeze both ends of the new
roll shaft, and insert and release the roll ends into the notches.
8. Finally, replace the retard roll. Squeeze the orange shafts of the retard roll and lift
out of the assembly.
9. Replace a new retard roll into the black notches of the assembly using the same
technique.
10. Reinstall the retard assembly into the tray. Align the cutout holes of the assembly
with the frame of the tray so the pin holes match up. Insert the assembly into the
frame. Slide the assembly all the way to the right using the pin as a guideline. Ensure
the device is all the way into the slots and the 3 screw areas align.
11. Screw in the 3 thumbscrews to attach the assembly. Do not overtighten.
12. Close the tray and verify that the tray is operating successfully by feeding paper
using that tray.
13. Either log in as the administrator or ask the administrator to perform the following
steps to reset the HFSI count to zero (0).
a) At the UI press the Machine Status button.
b) Select the Tools tab.
c) Select System Settings > Common Service Settings > Maintenance.
d) Use the up/down arrow buttons to access the next Maintenance screens.
e) Select the Technical Key Operator icon.
The Technical Key Operator feature displays.
17-5 Xerox ® Versant ® 80 Press
User Guide
1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)