Xerox Versant 80 Press, User Manual

Page: 227 / 382

3. Remove and replace the feed roll by squeezing the metal shaft and lifting out.
4. Remove and replace the nudger roll using the same technique.
5. Remove and replace the retard roll using the same technique.
6. Close the bypass tray cover.
7. Verify that the tray is operating correctly by feeding paper from the bypass tray.
8. Either log in as the administrator or ask the administrator to perform the following
steps to reset the HFSI count to zero (0):
a) At the UI press the Machine Status button.
b) Select the Tools tab.
c) Select System Settings > Common Service Settings > Maintenance.
d) Use the up/down arrow buttons to access the next Maintenance screens.
e) Select the Technical Key Operator icon. The Technical Key Operator feature
displays.
f) Select the MSI rolls item that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the HFSI to 0.
9. Exit the administrator mode by pressing the Log In/Out button on the UI. When
prompted, selectLogout.
Replacing the OHCF Feed Rolls (Trays 6 and 7)
The OHCF feed rolls should be replaced every 300,000 prints or when experiencing
frequent multifeeds, single feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the OHCF feed rolls, which includes:
• Feed Roll
• Nudger Roll
17-3 Xerox ® Versant ® 80 Press
User Guide
1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)