Xerox Versant 80 Press, User Manual

Page: 47 / 382

7. Load the postcard stock and adjust the paper guides against the stock.
8. Close the paper tray and confirm the new settings at the print server.
9. Run your print job.
10. Upon completion of your print job, remove the postcard stock and the Postcard
bracket from the tray.
11. Store the Postcard bracket inside the OHCF front cover area.
Skew Adjustment Levers (Trays 6 and 7)
The skew adjustment levers are found in all paper trays. These levers are used to improve
paper feed accuracy and to reduce paper skew problems.
1. Rear Skew Adjustment Lever
2. Right Side Skew Adjustment Lever
Note
These levers should remain in their default position. The position of these levers should
be changed only if there is a skew problem when running a specific print job and/or
media type. Changing the levers may cause more skew problems when running certain
media types such as coated, label, transparency and film.
Use the following procedure to set the skew adjustment levers:
1. Pull out the tray slowly until it stops.
The Tray Properties / Settings automatically display at the press User Interface (UI).
2. From the Tray Properties window, verify that the correct paper information is being
used including size, type, weight and paper curl or alignment option for the tray.
Select OK and close the Tray Properties window.
3. At the tray, slide the rear skew adjustment lever to the right.
4. Gently push in the tray until it comes to a stop.
5. Run your print job.
• The paper is fed accurately without skew and the printed output is satisfactory;
your task is complete.
• The paper is skewed and the printed output is unsatisfactory; proceed to the next
step.
6. Pull out the tray slowly until it stops.
3-11 Xerox ® Versant ® 80 Press
User Guide
Paper and Media