Xerox PrimeLink B9100, User Manual

Page: 262 / 484

European Union Lot 19 Ecodesign Directive
Per European Commission Ecodesign Directive, the light source contained within this product or its components is
intended to be used for Image Capture or Image Projection only and is not intended for use in other applications.
E N E R GY S TA R
The ENERGY STAR program is a voluntary scheme to promote the development and
purchase of energy-efficient models, which help to reduce environmental impact.
Details on the EN- ERGY STAR program and models qualified to ENERGY STAR can be
found at the following website:
www.energystar.gov .
The ENERGY STAR and ENERGY STAR mark are registered United States trademarks.
The ENERGY STAR Imaging Equipment Program is a team effort between United
States, European Union, and Japanese governments and the office equipment
industry to promote energy-efficient copiers, printers, fax, multifunction printers,
personal computers, and monitors. Reducing product energy consumption helps
combat smog, acid rain, and long-term changes to the climate by decreasing the
emissions that result from generating electricity.
For more information on energy or other related topics, go to www.xerox.com/about-xerox/environment/enus.html
or www.xerox.co.uk/about-xerox/environment/engb.html .
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device is designed
and configured to enable you to reduce your energy usage.
Energy Saver modes are enabled on your device to reduce energy consumption. After the last print, the device
transitions to Ready mode. In this mode, the device can print again immediately. If the device is not used for a
specified period, the device transitions to Low Power mode, then to Sleep mode. In these modes, only essential
functions remain active, to reduce power consumption. The device takes longer to produce the first print after it
exits the Power Saver modes than it takes to print in Ready mode. This delay is the result of the system waking up
and is typical of most imaging devices on the market.
O Offffiiccee PPrroodduuccttss oonnllyy
To save power, you can configure Energy Saver modes. The following options are available:
• Job Activated: The device wakes when it detects activity. To set the delay before the device enters Sleep Mode,
enter the number of minutes.
• Sleep and wake up at scheduled times: The device wakes and sleeps according to a schedule that you specify.
• Auto Power Off: To allow the device to power off after a period of time in Sleep Mode, select Auto Power Off. To
set the delay before the printer power off from the Sleep Mode setting, enter the number of hours.
Note: The USB Drive, and Wired and Non-Wired network activity resets the Energy Saver timers.
This printer is shipped from the factory with Xerox Remote Print Services diagnostics that can disrupt or delay Low
Power mode and Sleep mode. For settings of Xerox Remote Print Services features, contact your System
Administrator or refer to the
System Administrator Guide at www.xerox.com/office/PLB91XXdocs .
262
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide
Regulatory Information