Configuring the Network Address
Phaser® 8510/8560MFP Multifunction Product
2-6
Dynamic Methods of Setting the System’s IP Address
Set the system’s IP address using any of the following methods. DHCP is enabled by default
on all Phaser printers.
■
DHCP
■
CentreWare IS
■
AutoIP
Enabling DHCP on the System
Verify that the system DHCP protocol is enabled by setting the control panel or by using
CentreWare IS. DHCP is enabled by default.
Note:
To determine the system’s IP address, select
System Identification
. On the control
panel, press the
System
button, select
Information
, press the
OK
button, select
System
Identification
, and then press the
OK
button to view the system’s IP address.
See also:
Control Panel Features
on page 1-8
Information Required for Manual IP Addressing
Information
Comments
Internet Protocol (IP) address of the system
Format is
xxx.xxx.xxx.xxx
, where
xxx
represents
a decimal number from 0–255.
Network Mask
If you are unsure, leave this blank; the system
chooses an appropriate mask.
Default Router/Gateway address
Router address is required to communicate with
the host device from anywhere other than the
local network segment.