Adjusting Copying Options
Phaser® 8510/8560MFP Multifunction Product
4-9
Using the Prescan Glass Option
When using the document glass, you can prescan originals when using the auto center, edge
erase, auto reduce/enlarge, and poster options.
To select a prescan setting:
1.
On the control panel, press the
Copy
button.
2.
Select
Prescan Glass
, and then press the
OK
button.
3.
Select one of the following options:
■
Off
: Turns off prescanning. Select an original size for your copy.
■
On
: Turns on prescanning when any of the auto center, edge erase, auto
reduce/enlarge, and poster options are turned on. When all these options are turned
off, the copy area is calculated based on the current paper supply size.
Note:
The book copy option always prescans.
See also:
Selecting an Original Size
on page 4-8
Reducing or Enlarging the Image
You can reduce the image to 25% of its original size or enlarge it to 400% of its original size.
To use reduce or enlarge the image:
1.
On the control panel, press the
Copy
button.
2.
Select one of the following options:
■
Select
Preset
Reduce/Enlarge
, and then press the
OK
button. A list of preset values
appears from which you can select the size of the original followed by the size of the
copy paper.
■
Press the
Reduce/Enlarge
cascade
button on the control panel to select these options:
■
Auto
: Reduces or enlarges the image as needed to fit the full size of the copy
paper.
■
25%-400%
: Reduces or enlarges the image by a selected percentage: 25, 50, 100,
150, 200, and 400.
■
Press the up or down button below the three-digit LED to reduce or enlarge the
copy size in increments of one percent. 100% keeps the copy image the same size
as the original.
Note:
The factory default is 100%.