P o s t S c r i p t S I M M
C-12
❖
D o c u P r i n t 4 5 1 7
/
4 5 1 7 m p U s e r G u i d e
Removing a
PostScript SIMM
Caution
SIMMs and controller boards are sensitive to static electricity.
Before removing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the removal,
again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
1
Power OFF the printer and disconnect the power cord and any interface cables.
2
Loosen the thumb screws and pull out the
controller board.
3
Place the controller board on a ream of
paper.
chapterc.frm Page 12 Friday, July 11, 1997 9:17 PM
