I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s
C-4
❖
D o c u P r i n t 4 5 1 7
/
4 5 1 7 m p U s e r G u i d e
Memory
SIMMs
This section contains two sets of instructions:
•
“Installing a Memory SIMM”
(page C-4)
•
“Removing a Memory SIMM”
(page C-7)
Installing a
Memory SIMM
Note
Memory SIMMs for the DocuPrint 4517 are available in the
following sizes:
•
one-sided 4 MB and 16 MB
•
two-sided 32 MB
(See Appendix A: Ordering Printer Options for ordering
additional memory.)
Caution
SIMMs and controller boards are sensitive to static electricity.
Before installing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the installation,
again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
Note
Either 1 MB or 4 MB of the printer’s memory (depending on
the version of the printer) may become unusable when
2-sided 32 MB SIMMs are installed (or other non-Xerox
2-sided SIMMs, such as 8 MB or 2 MB). Thus the total system
memory may be less than the sum of resident and SIMM
memory when 2-sided SIMMS are used. To maximize usable
memory, we suggest selecting slot SIMM3 for a 2-sided
SIMM and not using 2 MB SIMMs in slot SIMM2.
chapterc.frm Page 4 Friday, July 11, 1997 9:17 PM
