M e m o r y S I M M s
C-6
❖
D o c u P r i n t 4 5 1 7
/
4 5 1 7 m p U s e r G u i d e
6
Make sure that the clips on either side
snap closed to lock the SIMM in place.
7
Replace the controller board, sliding it
along the alignment channels. Then
hand-tighten the thumb screws.
8
Replace the power and interface cables and power ON the printer.
After warming up for a few minutes, the Control Panel displays the following message:
Online
Ready
If any other message is displayed, see Table 6.2 starting on page 6-6.
9
Print a Configuration Sheet to verify that the SIMM has been installed properly.
A
Press Online
to take the printer offline.
B
Press Menu
, then Down
or Up
until you see:
Main Menu
Test Menu
C
Press Enter
and the message display changes to:
Test Menu
Config. sheet
D
Press Enter
again to print a Configuration Sheet.
E
After the Configuration Sheet prints, press Online
to put the printer back online.
On the Configuration Sheet, the “Total system memory” value should match the amount
of memory just installed plus the RAM resident on the printer (if not, see the note on
page C-4).
chapterc.frm Page 6 Friday, July 11, 1997 9:17 PM
