M a i l b o x / C o l l a t o r
C-46
❖
D o c u P r i n t 4 5 1 7
/
4 5 1 7 m p U s e r G u i d e
7
Attach the power cords.
A
Plug one end of the short (60 cm/2 foot)
Mailbox/Collator cord (1) into the AC
receptacle on the printer, and the other
end into the lower AC receptacle on
the Mailbox/Collator.
B
Plug one end of the printer power
cord (2) into the upper AC power
receptacle on the Mailbox/Collator, and
the other end into the wall.
8
Power ON the Mailbox/Collator (1) first,
and then power ON the printer.
This is the proper sequence to
always use when restoring power to
the system.
After warming up for a few minutes, the
Control Panel displays the following
message:
Online
Ready
If any other message is displayed, see
Table 6.2 starting on page 6-6.
9
Print a Configuration Sheet and check
that the Mailbox/Collator appears in the
“Installed Options” section. If not,
remove it as per Steps 1 to 3 on
page C-47, then repeat Steps 5 to 9 of this
procedure.
Note
Keep the original packaging material should you ever need to
remove the option.
chapterc.frm Page 46 Friday, July 11, 1997 9:25 PM
