DSC AND SCS DATA STREAM COMMANDS
Set Print Density (SPD)
2BD2nn2900cp
Defines the number of characters to print per horizontal inch
(CPI) or characters per line (CPL).
2B
Control sequence prefix of a Set Print Density
command
D2
Command class for Set Print Density
nn
Number of bytes in a command string including
the byte count
Valid nn are:
02 =
default value for CPI applies.
04 =
CPI is defined by cp.
Any other values cause the default value of CPI,
that is set at the printer, to be used and an
invalid SCS parameter check occurs.
29
Control type for Set Print Density command
00
One-byte number which must be X'00.'
cp
One-byte number expressed in hexadecimal that
specifies a CPI value for the emulations as
follows:
00 = 10 CPI
3812, 3268, 6262
0A = 10 CPI
3812, 3268, 6262
0C = 12 CPI
3812
0F = 15 CPI
3812
10 = 16.6 CPI
3812, 3268
11 = 17.1 CPI
3812, 3268
Default = X'00.'
An invalid cp parameter causes the CPI default
to be set at the printer, and results in an invalid
SCS parameter check.
Font Titan 17M is equal to 16.67 characters per
inch. The value of 16.67 is used when calculating
orientation.
Refer to the “Y3—Set Default CPI” section of the “Function
Selection via Line (FSL) commands” chapter for the FSL command
that impacts this SCS command.
XEROX MRP FAMILY COAX COMMAND REFERENCE
2-17
