wtw TresCon UNO A111, Operating Manual

Page: 194 / 208

Appendix TresCon UNO
8 - 16 ba43134e08 05/2017
Example:
Entering "69" for the Type of analyzer module means:
69 = 1 + 4 + 64,
i. e. TresCon should transmit the module mode, fluid levels and calib-
ration data for the analyzer module 1.
mscall TresCon can dial a number and transmit data at freely selectable inter-
vals. This function has to be activated with the mscall (ModemSetCall)
command:
Syntax:
mscallXXYYZZ,WW,Number,Type of terminal,
Type of analyzer module <CR>
After the interval has expired, TresCon starts to set up the connection
and sends the specified record. When the data has been transmitted,
the connection is terminated after a waiting period.
The transmission of the record looks as follows:
The callback is deactivated by sending the command,
"mscall0,0"
.
It can also be deactivated in the menu for initializing the modem (Deac-
tivating of modem). When doing so, all settings are deactivated.
Note
Before setting up the connection for the modem the modem is always
reinitialized. If the remote station is occupied or it is not possible to set
up the connection, the call is repeated three times.
XXYYZZ Time of the callback
WW Interval of callbacks in minutes
Number Modem number of the receiving address to be
called
Type... Record type (see under command, mgprot ).
07.05.03 12:15:34
Routine call
KA WM TresCon 2 (big cont.)
07.05.03 12:15:34 0.50 mg/l PO4-P
1: Measuring
+++
NO CARRIER