wtw TresCon UNO A111, Operating Manual

Page: 189 / 208

TresCon UNO Appendix
8 - 11 ba43134e08 05/2017
8.4 Interface commands
8.4.1 General RS commands
Designation of the
modules
In the interface commands, the modules are labeled with Tx as follows:

T0 = terminal

T1 = analyzer module

T2 = secondary measured value of the analyzer module if it provides
one (example: SAC value at the TresCon NOx-N/SAK analyzer
module).
All RS commands for the terminal start with T0.
Note
The RS commands of the individual modules are given in chapter 7
A
PPENDIX
of the module-specific sections of this operating manual.
T0GCURVEXX.XX.XX,
YY.YY.YY,ZZ,T1(,T2)
The graph in the time period xx:xx:xx to yy:yy:yy is printed. T1 is speci-
fied if module T1 should be printed, etc.
Example see “D
AILY
/
WEEKLY LOAD DIAGRAM
” on page 5-14.
T0GMEANXX.XX.XX,
T1(,T2)
The mean values from xx:xx:xx are printed. T1 is indicated if the T1
component should be printed etc. Only one component can be printed.
-----------------------------------------
Module 1
Reference day 18.7.03
Reference period for calculation 00:00 -
24:00
Mean value 12.13 mg/l PO4-P
Min. value 9.2 mg/l PO4-P
Max. value 17.3 mg/l PO4-P
Min. time 03:32 hours
Max. time 12.38 hours
-----------------------------------------
-----------------------------------------
TresCon>