87
The equivalent ICLI commands are:
# configure terminal
(config)# interface GigabitEthernet 1/2
! Enable Tag Classification
(config-if)# qos trust tag
! Map PCP 0 and DEI 0 to CoS 2 and DPL 0
(config-if)# qos map tag-cos pcp 0 dei 0 cos 2 dpl 0
! Map PCP 0 and DEL 1 to CoS 3 and DPL 1
(config-if)# qos map tag-cos pcp 0 dei 1 cos 3 dpl 1
(config-if)# end
Basic QoS: Tag Remarking per Port
Tag remarking on the egress frames can be done in three ways:
•
Classified: PCP and DEI values on the egress frames are updated with the classified values at the ingress. By
default, the PCP and DEI values are set to classified values.
•
Default: PCP and DEI values on the egress frames are updated to default values defined per port.
•
Mapped: PCP and DEI values on the egress frames are updated based on the tag remarking CoS/DPL to
PCP/DEI mapping per port.
Example
: Set Default PCP to 5 and DEI to 0 on Port 3.
Setting Up PCP Port Using WebGUI
To set the default PCP to 5 and DEI to 0 on Port 3, perform the following steps.
1.
Click
Configuration
>
QoS
>
Port Tag Remarking
.
2.
On the
Port Tag Remarking
page, click the
Port Number
corresponding to the port, and set the
parameters as shown in the following illustration.
