66
Group LACP Commands
The following snippet shows how to perform an additional configuration of LACP based groups.
# conf t
(config)# interface llag 1
(config-llag)# lacp ?
failover
max-bundle
failover—revertive (default) /non-revertive
max-bundle—max size of the aggregation (1-max). All the default ports in the group can aggregate.
Forwarding Mode of the Aggregation
The forwarding distribution of the traffic can be affected by changing the aggregation mode. This is a global parameter
and affects all aggregations. These mode parameters can be combined.
Note:
Any change in the aggregation mode stops all forwarding until the key is fully setup.
config)# aggregation mode ?
dmac
Destination MAC affects the distribution
ip
IP address affects the distribution
port
IP port affects the distribution
smac
Source MAC affects the distribution
(config)# aggregation mode ?
aggregation mode { [ smac ] [ dmac ] [ ip ] [ port ] }
(config)# aggregation mode smac dmac
(config)# end
#
Delete an Aggregation Group
The following snippet shows how to delete an aggregation group.
# conf t
(config)# no interface llag 1
(config)#
