19
The second section is LLAG/VLAN interface, press
interface LLAG (LLAG-ID)/VLAN (VLAN-ID)
in global configuration
mode. User can then enter the interface configuration mode. In this mode, User can configure the settings for the
specific LLAG/VLAN. To leave this interface mode type
exit
. Press
?
to see the available command list.
The command lists of the LLAG/ VLAN interface configuration mode.
The table below presents the summary of the 5 command modes:
COMMAND MODE
MAIN FUNCTION
PROMPT
Privileged EXEC
In this mode, the system allows User to view current
configuration, reset default, reload switch, show
system information, save configuration…and enter
global configuration mode.
#
Global Configuration
In global configuration mode, User can configure all the
features that the system provides User
(config)#
Port Interface Configuration
In this mode, User can configure port related settings.
(config-if)#
LLAG / VLAN Interface
Configuration
In this mode, User can configure settings for specific
LLAG/VLAN.
(config-if)#
Here are some useful commands for User to see these available commands. Save User time in typing and avoid
typing error. Press
?
to see all the available commands in this mode. It helps User to see the next command User
can/should type as well.
#LLAG
(config)# interface llag ?
1-5 ID of LLAG interface
(config)# interface llag 1
(config-llag)# ?
do To run exec commands in the configuration mode
end Go back to EXEC mode
exit Exit from current mode
help Description of the interactive help system
lacp
no
#VLAN
(config)# interface vlan ?
<vlan_list> List of VLAN interface numbers
(config)# interface vlan 1
(config-if-vlan)# ?
do To run exec commands in the configuration mode
end Go back to EXEC mode
exit Exit from current mode
help Description of the interactive help system
ip IPv4 configuration
no Negate a command or set its defaults
