101
Queue Policers
Example
: Enable policer on Queue 2 at Port 2. Set the policing rate to 20 Mbps.
Configuring Queue Policer on a Port Using WebGUI
To configure Queue Policer on Queue 2 at Port 2 and set the policing rate to 20 Mbps, perform the following
steps.
1. Click
Configuration
>
QoS
>
Queue Policing
, and configure the policer as shown in the following illustration.
Set Up Queue Policer Rate in Mbps Throughput
The equivalent ICLI commands are:
# configure terminal
! Enable Policer on Queue 2 at Port 2 with a rate set to 20 Mbps (config)# interface GigabitEthernet
1/2
(config-if)# qos queue-policer queue 2 20 mbps (config-if)# end
Shapers
Port Shapers
Enable shapers at port level to shape the egress traffic.
Example
: Enable shaper on Port 3 and set the shaping rate to 4 Mbps.
Configuring Shaping Rate (Mbps) on a Port Using WebGUI
To enable a shaper on Port 3 and set the shaping rate to 4 Mbps, perform the following steps.
1.
Click
Configuration
>
QoS
>
Port Shaping
.
2.
Port Shaping
page, click the
Port Number
corresponding to the port, and set the
Scheduler Mode
and
Rate
as
shown in the following illustration.
