103
Multiple Queues with Different Queue Shaper Rates
The equivalent ICLI commands are:
# configure terminal
! Enable Queue Shaper on Queues 3 and 4 on Port 3 and set the rate to 4 and 8
! Mbps. Use data rate.
(config)# interface GigabitEthernet 1/3
(config-if)# qos queue-shaper queue 3 4 mbps rate-type data (config-if)# qos
queue-shaper queue 4 8 mbps rate-type data (config-if)# end
Schedulers
DWRR
Example
: Set the scheduling mode to DWRR (6 Queues Weighted) on Port 3 with the following weights: Queue0- 40,
Queue1-40, Queue2-20, Queue3-20, Queue4-20, and Queue5-20.
Configuring Scheduling Mode to DWRR Using WebGUI
To configure Scheduling Mode to DWRR on Port 3 with the following weights: Queue0- 40, Queue1-40,
Queue2-20, Queue3-20, Queue4-20, and Queue5-20, perform the following steps.
1.
Click
Configuration
>
QoS
>
Port Shaping
.
2.
On the
Port Shaping
page, click the
Port Number
corresponding to the port, and configure the
Queue Scheduler
as shown in the following illustration.
