Winterthur Gas X40-B, Maintenance Manual

Page: 425 / 495

Maintenance
8460 − 1/A1
Winterthur Gas & Diesel Ltd.
5/ 5
4. Adjustment
1) Make sure that the claw (3, Fig. 6 ) is
correctly attached to the hydraulic
pipe (4).
2) Attach new O-rings (1, 2) to each end
of the hydraulic pipe (4).
3) Make sure that there is a distance of
5.0 mm between the end of the
hydraulic pipe (4) and the claw (3).
Note: You can adjust the claw (3) with an
open-ended wrench.
5. Installation
CAUTION
Damage Hazard: Make sure
that you do not damage
the sealing faces (SF) or
the hydraulic pipes. Do not
apply lateral force to the
hydraulic pipe and the
flanges.
1) Remove all of the protection from the
sealing faces (SF, Fig. 7 ) in the top
housing (3, Fig. 9) and the VCU (6).
2) Apply oil to the threads of the
screws (2, 5).
3) Carefully put the hydraulic pipe (1) in
position in the top housing (3) and the
VCU (6).
4) Torque symmetrically the four
screws (2) to 40 Nm.
5) Make sure that there is a distance of
11 mm between the flange (4) and the
top housing (3).
6) Torque symmetrically the four
screws (5) to 40 Nm.
7) Make sure that there is a distance of
11 mm between the flange (7) and the
VCU (6).
Note: After 1000 operation hours, do step
4 ) to step 7 ) again.
8) Set to on the main bearing oil supply.
2016
Hydraulic Pipe: Removal, Grind the Sealing faces and Installation
5.0 mm
Fig. 6
1
4
3
2
WCH03769
11 mm
11 mm
II - II
WCH03769
WCH03769
SF
Fig. 7
I - I
4
1 2
3
7
1
SF
5
6