Winterthur Gas X40-B, Maintenance Manual

Page: 257 / 495

Maintenance
3303 − 5/A1
Winterthur Gas & Diesel Ltd.
3/ 4
9) Attach the chain block (94017C, Fig. 4 )
to the gallery.
10) Operate the two manual ratchets
(94016F) to move the bearing cover to
the fuel side.
11) Attach the chain block (94017C) to the
chain (94335D).
12) Operate the two manual ratchets
(94016F) and the chain block (94017C)
to move the bearing cover (1) to the fuel
side.
13) Lower the bearing cover (1) on to an
applicable surface.
14) If necessary, remove the chain (94335D)
from the bearing cover (1).
3. Installation
1) Make sure that the bearing cover (1) has
no damage.
2) If necessary, attach the chain (94335D)
to the bearing cover (1).
3) Operate the the two manual ratchets
(94016F) and the chain block (94017C)
to move the bearing cover (1) to a
position near the crosshead.
4) Carefully remove the chain block
(94017C) from the chain(94335D).
5) Operate the manual ratchets (94016F)
to move the bearing cover (1, Fig. 5 ) to a
position directly above the elastic bolts.
CAUTION
Damage Hazard: Before
you operate the manual
ratchets, make sure that the
bearing cover is level and
vertically aligned with the
center of the crosshead pin.
This will prevent damage to
the elastic bolts.
6) Carefully lower the bearing cover (1) on
to the crosshead pin. Make sure that you
do not damage the elastic bolts (3).
Note: In Fig. 5 , some parts can look
different.
7) Make sure that the holes in the bearing
cover (1) engage with the four dowel
pins (2).
2016
Top End Bearing Cover − Removal and Installation
Fig. 4
Fig. 5
I
2
3
WCH02664
WCH03653
94017C
94016F
94335D
94016F
94019F
1
94019F
WCH03653
94335D
94016F
I