Specialized Concentrated Focused
「
46
」
Machining Operations
axes can be jiggled, and the system is in
―Stepping‖ mode by default. Each press of an axis direction key
will make the corresponding axis move a specified step.
The operation steps are as follows:
1) Press
in the process of machining, and then press
+
to enter the jiggle page.
2) Press
―
↑
‖ or ―
↓
‖ to select a step size from ―0.01‖, ―0.02‖, ―0.05‖, ―0.10‖, ―0.20‖, ―0.50‖ and ―1.00‖.
3) Press one of
―4‖, ―6‖, ―2‖, ―8‖, ―3‖ and ―9‖ to execute jiggle on the desired axis in the corresponding
direction.
4) Press
―Start‖ to resume machining after jiggle.
CAUTION
If hard limit, soft limit or E-stop occurs in jiggle, the system will stop jiggle, give a limit prompt or an alarm, and
return to the main page.
4.10.4.
Continuing Machining after Pause
When the system is in the state of pause, pressing the start key
will continue machining from the
pause position, running status at the top right corner of the screen changing from
―Paus‖ to ―Run‖; at the
same time, the machine tool continues machining.
4.10.5.
Soft Limit Handling
Soft limit occurs when an axis exceeds the setting range of
―MachineStroke‖ during machining, and the
system will display a limit dialog as shown below.
O K
E S C
X S o ft L im it
Fig. 4-18 Soft limit dialog
Press [OK] or [ESC] to exit from this warning dialog and return to the machining page, and then manually
move the limit axis towards the reverse direction to release limit. After soft limit occurs, the system
prohibits the limit axis from moving towards the limit direction.
4.10.6.
Hard Limit Handling
The system detects hard limit periodically under the main page. When hard limit occurs, its prompt dialog
