Specialized Concentrated Focused
「
50
」
Machining Operation of NK105G3F
Where:
Press
-
or
-
.
-
to increase or decrease the feedrate override.
5.3.2.
Spindle Speed Adjustment
Spindle speed are adjusted by pressing combination key
+
-
or
+
-
.
-
, and
divided into 11 gears from 0.5s to 1.5s with speed increasing sequentially.
5.3.3.
Machining Pause and Jiggle
Refer to chapter 4.10.3 for details.
Where:
Press
+
to enter the jiggle page.
5.3.4.
Soft/Hard Limit Handling
Refer to chapter 4.10.5 and chapter 4.10.6 for details.
5.3.5.
E-stop Handling
When E-stop occurs, the system will stop machining, and give an alarm as shown in Fig. 5-2, the
―ALM‖
indicator on the panel ON. Before executing any other operations, remove this alarm by turning the
E-stop button clockwise.
After E-stop alarm is removed, home all the axes, and then press
+
to execute breakpoint
resume, i.e. to resume machining from the stop position when E-stop occurs.
1 X 1 5 .6 1 7 E stp
1 Y 5 5 1 .1 0 7 S O ff
1 Z 9 .9 0 0 S lo w
J o g
E S T O P 2
Fig. 5-2 E-stop alarm
CAUTION
In E-stop state, all the other keys are invalid except the “Menu” key. You can press the “Menu” key to enter the
menu page and make desired changes.