Specialized Concentrated Focused
「
42
」
Machining Operations
4.8.2.
Parameter Setting of Manual Machining
Basic parameters of manual machining include: rapid jog speed (i.e.
―High‖ shown in the machining
page), jog speed (i.e.
―Slow‖ shown in the machining page), XY step, Z step and A step.
Table 10 Parameters for manual machining
Parameter
Meaning
Setting range
MSpd (High)
Two types of speed under manual
machining, deciding the axis motion speed
during manual machining.
0.06~Max. speed of machine tool
MSpd (Slow)
0.06~Rapid jog speed
Step X/Y/Z/A
The motion distance of the corresponding
axis each time an axis direction key of
X/Y/Z/A is pressed.
0.001~10000mm
The max. speed of a machine tool is related with the setting of pulse equivalent. For the concrete
expression, see Chapter 4.3.
Jog speed (Slow) and rapid jog speed (High) are switched by pressing
0
.
The concept of stepping (also called gridding in some other systems) is introduced for the accuracy
of machining and debugging. When the system is in the stepping mode, step is the motion distance
of the corresponding axis each time an axis direction key of X/Y/Z/A is pressed.
Under the main page, press the [OK] key to enter the parameter setting page of manual machining, as
shown in Fig. 4-13.
M S p d
S tep X Y
S tep Z
F ile
< F L O W E R .G >
3 0 0 0 / 1 5 0 0
1 0 .0 0 0
1 .0 0 0
1 5 0 0
Fig. 4-13 Manual parameter setting page
Press
―Up‖ or ―Down‖ to select the desired parameter, and then press [OK] for confirmation after
modification. Note that modification should be within the parameter range.
Current file name is displayed at the bottom of the LCD. Press
―Up‖ or ―Down‖ to move the cursor to the
file name, and then press [OK] to enter the file list of C disk, as shown in Fig. 4-14. You can only load
these files, unable to delete or copy them under this page.
F L O W E R .G
T estin g .d x f
T o o l.n c
C
：
[O K ] L o a d
Fig. 4-14 File list page
If there is no file in the C disk, the prompt
―File Not Found, Show USB File?‖ will be displayed; press [OK]
