Specialized Concentrated Focused
Machining Operations
「
39
」
D an g ero u s
o p eratio n ,
O K
E S C
Fig. 4-8 Dangerous prompt for operation of backing to machine origin
At this time, you can press the [OK] key to enter the machining page and execute backing to machine
origin for the selected axis, or press [ESC] to cancel and return to the previous page.
4.7. Spindle Debugging
This system can control spindle motor through parameters of
―Spindle Gears‖, ―ON/OFF Delay‖, ―Initial
Gear
‖ and ―Max. Spdl Speed‖. Spindle speed can also be changed during machining under the condition
that the interface board and inverter have been well connected.
4.7.1.
Spindle Setup
Press the
―Menu‖ key
→
5. Mfr Param
→
6. Spindle Set, and then press the [OK] key to enter the spindle
setup interface, in which press the
―Up‖ or ―Down‖ key to select the corresponding parameter for
modification.
ON/OFF Delay
Since it takes some time for the spindle to reach the rated rotary speed or stop completely, tool damage
or a scrap may happen if machining starts before the spindle reaching the rated rotary speed or other
actions are performed before the spindle stopping completely. This parameter set the delay time for the
spindle to reach the set spindle speed or stop completely when turned ON or OFF.
Spindle Speed
It specifies the spindle speed during auto machining, with its value no more than
―Max. Spdl Speed‖.
Max. Spdl Speed
It refers to the max. Rotary speed of the spindle, with its value consistent with the setting of inverter.
Modification to this parameter becomes effective after reboot.
4.7.2.
Park MCS Site
Press the
―Menu‖ key
→
3. Operations
→
5. Park MCS Site, and then press the [OK] key to enter the
interface of
―Park Mode‖ and ―Park Site‖, as shown in Fig. 4-9. The position of the spindle after the end of
machining can be set here.