Specialized Concentrated Focused
References
「
55
」
Parameter
Meaning
Setting range
Lifting Height
It sets the tool lifting height of Z axis during rapid
traverse when an ENG file is being processed.
0~99999 mm
ToolChangeTip
It sets whether to pause and prompt tool change when
tool change command is encountered during ENG file
machining.
Yes: Valid; No: Invalid
Cycle Times
It sets the cycle times to process an Eng file.
0~100000
Deep Hole
Mode
Mode selection for deep hole machining
0: Reciprocating chip
removal
1:High-speed
reciprocating
chip
removal
Retract Amount
Retract amount after each feed in high-speed
reciprocating chip removal mode
0~99999999 mm
Select ToolNo.
If this parameter is set to
―Yes‖, the machining will be
executed in terms of the specified tool No. in the
machining file and only this file will be processed.
Yes: Valid; No: Invalid
Plt Params
Lifting Height
It sets the tool lifting height of Z axis during rapid
traverse when a PLT file is being processed.
0~99999 mm
Plt Unit
Normally, 1plt=40.195mm, which can be enlarged or
diminished by setting this parameter.
0.001~99999
Tool step
The value should be confirmed in terms of the tool
diameter and make the adjacent tool paths overlap for a
full machining.
0.0001~99999 mm
Processing
Depth
It specifies the machining depth for 2D files.
-99999~0 mm
DXF parameters are for the translation of DXF files. In DXF file machining, the system treats the
action of tool lifting as the separate mark for the adjacent shapes, If there is no tool lifting, the system
will consider only one shape is being processed. If tool lifting occurs, it indicates the machining of a
complete shape is finished. For example, process several circles adjacent to each other. The depth of
each circle is 10mm, and each feed depth of Z axis is 2mm. If the parameter
―Shape Process‖ is set to
―Yes‖, the machine tool will process the current circle 5 times, and then lift the tool, and then go to
process the next circle. If it is set to
―No‖, the machine tool will process the current circle once, then lift
the tool, and then go to process the next circle. After all the circles are processed once, this process
will be re-executed 4 times to finish machining all the shapes.
ENG parameters are for the translation of ENG files.
PLT parameters are for the translation of PLT files. PLT is a format of 2D machining files defined by an
American company
—
Hewlett Packard (HP), usually used in embossment and advertising carving. At
the same time, PLT is also a kind of unit. Normally, 1plt=40.195mm, which can be enlarged or
diminished by setting the parameter
―PLT Unit‖.