Specialized Concentrated Focused
Machining Operations
「
45
」
Method two takes advantages of tool measurement. Press
+
0
to execute movable
tool measurement. After measurement, coordinate of Z/A axis is the workpiece origin of Z/A axis.
4.9.4.
Start Machining
Press the start key
to start automatic machining in the machining page.
Prompts like feedrate override and feed rate are scrolled on the LCD during file machining.
4.10. Adjustment
during
Automatic
Machining
4.10.1.
Feedrate Override Adjustment
Feedrate override can be increased or decreased by pressing
or
during file machining.
And the feed rate changes with the feedrate override. The relation between actual feed rate and feedrate
override is as follows:
Actual feed rate = Feed rate × Feedrate override
The least unit of feedrate override is 0.1. Namely, override increases (decreases) by 0.1 after each press
of
or
; at the same time, the feedrate override displayed on the LCD increases (decreases)
by 10%. The range of feedrate override is within 0%~120%. In addition, the display of feed rate value
changes with the feedrate override.
4.10.2.
Spindle Speed Adjustment
Spindle speed are adjusted by pressing
+
or
+
, and divided into 11 gears
from 0.5s to 1.5s with speed increasing sequentially.
4.10.3.
Machining Pause and Jiggle
If machining is found not in position exactly, suspend the machining and then execute manual jiggle.
Suspend machining by pressing the
―Pause‖ key in machining, ―Paus‖ displayed at the top right corner of
the LCD while the machine tool stopping moving; as for the spindle, whether it stops or not is decided by
the setting of the parameter
―SOff at Pause‖. Whether the spindle stops or not, at this time, the three
