Specialized Concentrated Focused
System Page
「
21
」
hole for the third workpiece of the same batch within G56 WCS.
Applicable to all WCSs, public offset is used to adjust the workpiece origin of X, Y and Z axes, without
changing the offset value of G54~G59.
Workpiece offset, tool offset and public offset meet the following expression:
Workpiece coordinate = Machine coordinate
– Workpiece offset – Tool offset – Public offset
3.3. Spindle State
Including spindle speed gear and spindle stop. In idle state, press
to switch. In machining state,
press combination key to
+
or
+
increase or decrease the gear, which is divided
into 11 gears from 0.5s to 1.5s with speed increasing sequentially.
CAUTION
Slightly different from NK105G2F system, you can press
to switch between spindle start and stop; and in
machining state, press combination key
+
-
or
+
-
.
-
to increase or decrease the spindle speed
gear.
3.4. Manual Speed Type
Manual speed is divided into manual high speed (also called rapid manual speed) and manual low
speed (also called manual speed), which can be switched by pressing
0
. Refer to chapter 5.1.2 for
details about speed setting methods.
3.5. Menu Page
Press
to enter the menu page. There are altogether 8 parameter items in the menu but the LCD
can only show 4 of them at a time, as shown in Fig. 3-5.
