Specialized Concentrated Focused
「
24
」
System Page
CAUTION
After setting parameters and moving the cursor to “Load Now”, you still need to press [OK] to load the machining
file.
If the input value of “EngrDpth” is too big, the system will send the warning information “Too many file layers
generated, continue?”, as shown in Fig. 3-9. You can press [ESC] to back to modify the value; or press [OK] to
load the file anyway, the system staying in the page shown in Fig. 3-9. At this time, if you press a key, its function
will not be executed until this dialog box disappears, so it is not allowed to press any key under this state. You can
wait patiently until the file is successfully loaded, or you can power off and re-power on the system.
T o o m an y file
lay ers g en erated
O K
E S C
Fig. 3-9 Warning dialog when parameters not properly set
Select Line No.
This page shows the loaded file information, like total line No., start line No. and end line No. The default
setting of
―StartLine‖ is the breakpoint position of the current file, and ―EndLine‖ the last line. With this
function, you can select any blocks to be processed. After these values are set, press the
―Up‖ or ―Down‖
key to select
―Execute Now‖, and then press [OK] to start machining instantly.
CAUTION
The default line No. of “StartLine” is the breakpoint line No. under this page.
Machining Info
After this item is selected and [OK] is pressed, the system will analyze the file currently loaded
automatically, like calculating the needed time for file machining and the machining range of each axis.
The page of analytic result is as shown in Fig. 3-10.
T i m e : 0
：
1
：
4 2
X
：
Y
：
Z
：
1 0 8 2 0 5
2 0 1 1 7
0 5
Fig. 3-10 Analytic result of machining
Park MCS Site
For details, refer to chapter 4.7.2.
