Specialized Concentrated Focused
Machining Operation of NK105G3F
「
49
」
Where:
To load an ordinary file, press
1
IV-
to load the selected file.
To load an ENG file with tool selection function, press
1
IV-
to automatically enter the tool selection
page.
5.2.2.
WCS Selection
Refer to chapter 4.9.1 for details.
5.2.3.
Set Workpiece Origin
Workpiece origin is the zero of X, Y, Z and A in the machining file. Before machining, you must set
workpiece origin to determine its actual position.
Manually move the X and Y axes to the desired origin position, and then press
X=0
for XY clearing,
i.e. to confirm the position of XY workpiece origin. You can also press
+
X=0
and
+
Y=0
Z=0
to execute X clearing and Y clearing separately.
For Z workpiece origin, there are two ways to set it:
Method one is the same as that to set XY workpiece origin. Manually move the Z axis to the desired
origin position. And then press
Y=0
Z=0
for Z clearing, i.e. to confirm the position of Z workpiece
origin.
Method two takes advantages of tool measurement. Press
+
to execute mobile tool
measurement. After measurement completed, the coordinate of Z axis is Z workpiece origin.
5.2.4.
Start Machining
Refer to chapter 4.9.4 for details.
5.3. Adjustment
during
Automatic
Machining
5.3.1.
Feedrate Override Adjustment
For details, refer to chapter 4.10.1.
