WEG MVW3000 A0040 V023, User Manual

Page: 89 / 125

MVW3000 | 9-1
9
Communication Networks
MVW3000 | 9-1
9
MVW3000 | 9-1
9 COMMUNICATION NETWORKS
The MVW3000 can be connected to communication networks allowing its control and parameterization.
Therefore, it is necessary to install an optional electronic board according to the desired Fieldbus standard.
NOTE!
The chosen Fieldbus option can be specified in the suitable field of the MVW3000 model coding. In such
case, the MVW3000 will be supplied with all the necessary components already installed in the product.
In case of a later purchase of the Fieldbus optional kit, the user must install it.
9.1 FIELDBUS KIT
9.1.1 Installation of the Fieldbus Kit
The Fieldbus kit communication board is installed directly on the MVC4 control board, connected to the XC140
connector and fixed by spacers.
NOTE!
Follow the safety notes presented in the Chapter 1 SAFETY NOTICES on page 1-1 .
In case there is a function expansion board (EBA/EBB/EBC) installed, it will be necessary to remove it for a while
so as to allow the installation of the chosen Fieldbus Kit.
1. Power down control Rack.
2. Remove the bolt from the metallic spacer next to the XC140 connector (MVC4 board).
3. Carefully fit the male XC140 connector into the correspondent MVC4 connector. Verify the exact coincidence
of all the XC140 connector pins (
Figure 9.1 on page 9-1 ).
Figure 9.1: Fieldbus electronic board installation