WEG MVW3000 A0040 V023, User Manual

Page: 44 / 125

6-4 | MVW3000
6
Installation, Connection and Energization
ATTENTION!
If any component presents problems (damages) it is recommended to:
„
Stop the unpacking immediately.
„
Contact the carrier and formally fill in a complaint with the problem found.
„
Take pictures of the damaged parts.
„
Contact your WEG representative or service.
Figure 6.2: Standard power cell with package
6.1.6 Positioning/Mounting
The MVW3000 panel must be placed on a flat leveled surface, thus avoiding mechanical instability, door
misalignment, among other problems.
ATTENTION!
Some models of the MVW3000 are transported with some parts disassembled.
All disassembled parts must be properly assembled during the commissioning.
The permanent operation position must allow heat radiation from all the surfaces and the necessary ventilation
for its operation. The area in front of the panel must remain unobstructed, so that a total opening of the doors be
possible, as well as the insertion and extraction of the arms and/or the power and control cables.
Table 4.2 on page 4-3 to Table 4.8 on page 4-4 present the dimensions of the available panels.