WEG MVW3000 A0040 V023, User Manual

Page: 14 / 125

2-2 | MVW3000
2
General Information
2.2 MVW3000 IDENTIFICATION LABEL
The MVW3000 identification label is positioned in the inner part of the Control Panel of the product. This label
describes important information about the inverter.
Figure 2.1: MVW3000 identification label (example)
2.3 RECEIVING AND STORAGE
The MVW3000 is supplied with the power cells separate from the panel and packed in sets of three cells per
package. The package is composed of OSB frame and injected foam shims. An identification label is affixed to
the outside of the package, identical to the label affixed to the side of the inverter. Compare the content of this
label to the purchase order.
In order to open the cells, see the procedures described in Item 6.1.5 Unpacking on page 6-3 . If the MVW3000
cells are not install on the cabinet soon, store them in a clean and dry place (temperature between -25 °C ( -13 °F)
and 50 °C (122 °F) and humidity below 80 %), covered so as protect from dust accumulation and water splashes.
It is recommended to replace the silica gel every three months.
The MVW3000 cabinet has a dehumidifier module, which must remain turned on in case of storage for over thirty
days.
The MVW3000 cabinet is supplied in a cardboard and wood package. The directions for handling, transportation,
mechanical and electrical installations of the product are described in
Chapter 6 INSTALLATION, CONNECTION
AND ENERGIZATION on page 6-1 , in Item 6.1.5 Unpacking on page 6-3 .