G
ETTING
S
TARTED
IEC61000-3
S
OFTWARE FOR
W
INDOWS
U
SER
M
ANUAL
Page 32
VPN 98-025/7
Voltech Instruments
Name
Identifies your AC Source. Manufacturer and model number should be
entered.
Commands
Enter here the AC Source commands that should be issued by the software
to turn the source output on and off during testing and to set up the
frequency of the source (usually 50Hz).
Voltages
Enter here the voltages at which you wish to test and their respective AC
source commands. Normally only 230V is necessary.
Range and output impedance commands may be required to set some
sources up correctly.
Source command delay
Enter here a time in milliseconds if you are experiencing communications
problems. It is possible for the software to issue consecutive commands
before a source is ready for them. If in doubt, start with a long delay
(1000mS) and shorten the delay if required.
Source ON OFF prompt
By default this box is not checked and the software will automatically turn
the source off and on when required. If this box is checked, the software
will prompt for confirmation that you want the source turned off at the end
of the test. In this way the source can be left on permanently.
Summary of Contents for PM3000ACE
Page 4: ......
