Voltech AT360, User Manual

Page: 167 / 470

P
ROGRAM
E
DITOR
V
OLTECH
AT
I
U
SER
M
ANUAL
P
AGE
3-45
(xxx1) and a current over-range (xxx2) have occurred at the same time during
test, then the error code is *0003* (i.e., both bits 0 and 1 set in the 16 bit binary
error code).
If a test has failed due to an interrupt, then an additional code is attached to
bits 12-15 of the error code as the table details further.
Hex Code
Error
0000 Test passed with no errors.
xxx1 Voltage over-range occurred.
xxx2 Current over-range occurred.
xxx4 Ramp-up process has been aborted; too much load.
xx2x The test parameters could not be trimmed to required value;
incorrect test parameters for the load.
xx4x An error occurred after ramp-down; current did not decay away in
time.
x1xx Current limit fail (hi-pot tests only); test current exceeded pre-
programmed limit (AT3600 only).
x2xx Voltage present (Vpres) did not go away in time; something on the
fixture is staying charged (AT3600 only).
#4xx The test has failed due to an interrupt (see table below).
Where # = reason for interrupt fail.
1 The safety interlock interrupt has terminated the test; a break has
occurred from the safety interlock port (AT3600 only).
3 A hi-pot trip interrupt has terminated the test; a flashover has
occurred or the current has exceeded the AT’s current capabilities
(can occur on HPAC, HPDC and IR) (AT3600 only).
4 A STOP interrupt has terminated the test from the STOP flag of the
remote port.
5 An 8kV interrupt has terminated the test - voltage > 8kV (AT3600
only).
7 An over-temperature interrupt has terminated the test; unit has
become too hot (AT3600 only).
8 An auxiliary trip interrupt has terminated the test; this can be
created by an attached device to the peripherals port.