Voltech AT360, User Manual

Page: 104 / 470

G
ETTING
S
TARTED
P
AGE
2-70 V
OLTECH
AT
I
U
SER
M
ANUAL
Note
The third line, showing the graphical comparison of the measured value and
test limits, has a logarithmic scale. The measured value may be represented
by either a vertical bar (as shown), when it lies within the range that can be
displayed on the LCD, or by an arrowhead (< or >), at the end of the horizontal
bar, when it lies outside the range that can be displayed on the LCD.
Pressing the ‘Abort’ softkey stops the program and allows the operator to
discard the failing component at the earliest opportunity to minimize test times.
(The abort is also reported to the Server when the program option 'Send retry
results to server' is enabled and printed out, when a results printing option is
set.)
After pressing the ‘Continue’ softkey, the remaining tests in the program will be
executed. ‘Stop on Fail’ will remain active, and any subsequent test that also
fails will produce a similar display. At the end of the measurement, the
component will be classed as a ‘Fail’.
Pressing the ‘Re-Run’ softkey will re-start the test sequence from the
beginning.
You would normally press ‘Re-Run’ if the failure were caused by the
component being incorrectly inserted into the fixture. Unless the option ‘Send
retry results to server’ is enabled, at this point, there will be no data sent back
to the Server. Therefore, after you have corrected the mistake, following the
re-run, good transformers will be reported as ‘Pass’.