Voltech AT360, User Manual

Page: 352 / 470

T
ESTS AND
T
EST
C
ONDITIONS
P
AGE
7-54 V
OLTECH
AT
I
U
SER
M
ANUAL
> A minimum value only
< A maximum value only
Use the PC Editor’s ‘Measure’ button (together with a sample part) if you are
unsure of the nominal value.
Remember to click on the units of limits (pF, nF etc.) when entering absolute
values as limits.
Test limits should be set as close as possible to the nominal value in order to
detect faults. A typical tolerance would be
±
20%.
If the "User Offset Enabled" check box is checked, a value can be entered into
the edit box. The value entered is then added to any results returned from the
AT tester.