Voltech AT360, User Manual

Page: 67 / 470

G
ETTING
S
TARTED
V
OLTECH
AT
I
U
SER
M
ANUAL
P
AGE
2-33
2.3.5 Server Quick Start
Transferring the Program to the Server
The Voltech Server software is supplied with every AT Series Tester. The use
of the Server software is required for handling and storage of test results and
is recommended for handling large numbers of different test programs.
Having created, saved and tested the program TUTORIAL using the Editor,
you are now in a position to run it again on your AT Series Tester, but this time
using the Server. The procedure for transferring the program to the Server
archive will depend on where you have installed the Editor and Server
programs.
Editor and Server on Separate PC’s
In many situations the Editor and Server can be installed on separate PC’s (as
shown in the illustration earlier). In this situation, the AT is used to perform the
transfer.
Before proceeding further, make sure that all the following have been set up:
•
The interface cable between the tester’s auxiliary port and the selected
COM Port on the Editor PC is correctly fitted, and that the COM Port is
correctly configured in the Editor software (see the Editor quick start
earlier).
•
The interface cable between the tester’s server port and the selected
COM port on the Server PC is correctly fitted, and that the COM Port is
correctly configured in the Server software (see earlier).
•
Both the Editor and the Server software packages are running.
•
The tester is still powered on as described above.